Achieved many technological breakthroughs in sensor and processor, network camera in clarity compared to traditional analog equipment has been greatly improved, so the network monitoring equipment on the market 1,300,000 2,000,000pixel high-definition products 300 million -500 million-pixel high-definition products are also many, In addition, thanks to the advantages of digitization, network camera is also embedded in a smart analysis of application functionality, for HD application solutions also increasinglymature, clarity, low light or wide dynamic image performance effect, they have a good performance. However, due to its own more efficient operating characteristics, network surveillance camera began more act as a monitoring outpost ". The ip camera are installed in the complex environment of the outdoor environment or harsh environments, remote place, or is located in a prominent place in the family. If we use in the operation or improper maintenance, is likely to speed up the aging of the ip camera and scrap speed This unique structure of the network camera equipment, we need more information in the course of Notes. 1, regardless of the ip camera boot or shutdown state must avoid a strong light source While most of today's ip camera are equipped to deal with obvious light poor wide dynamic function, but as the distinction between the general environment under illumination remedies, or difficult to withstand the direct exposure to strong light source. Perhaps many users that work only in the ip camera when it is not directly face the glare, but the shutdown of the network camera, like the need to pay attention to avoid a strong light source. Whether the network camera is in use or off, not long scene opposite the sun or other bright light, otherwise, as the very high light sensitivity of optical equipment, continuous bright light easily caused by the image sensor device damage to cause image blur, or halation phenomenon. The continuous shooting of the ip camera in the bright light, and is very easy on a display screen forms the spot, while the portion of the image will appear to fade phenomenon because the ip camera's CCD color filter work environment is changed. 2, try not to use water to clean the lens, the lens is the core component of the network surveillance camera, focus on the need for such critical equipment maintenance, network monitoring equipment for the home, lack of special protection similar to field applications, instead most vulnerable to the pollution of the surrounding dust. And for monitoring lens cleaning, we should be avoided as much as possible to clean up the liquid to its avoid water droplets into the lens or lens damp phenomenon. Of course, if more dirt on the lens and had the need to use liquid cleaning, we also must use neutral detergent spray, special cleaning cloth to wipe. And wipe complete with a dry cloth to dry the residual moisture on the lens, so as to avoid the lens phenomenon of wet. It has been rumored to have a good effect, some of the glass surface with an alcohol wipe lenses for surveillance camera, however, because alcohol has a strong corrosive, so should never use it to wipe the surface of the lens. 3,Do not disassemble network surveillance camera, for traditional analog surveillance camera, because they have gone through a very long period of development and application, so the user is very familiar with the technical structure of the ip camera, many relatively experienced users have been able to own a simple solve the fault of the use of analog ip camera. For network camera, because it has a higher technological content and more sophisticated structure inside the device has been basically the board as well as a variety of tubes replaced. So you best not attempt to disassemble the fuselage or remove the housing is not necessary the case, in order to avoid damage to other parts of the failure to expand is not familiar with the internal structure. 4, try to install the network camera is not obvious changes in temperature and humidity, for surveillance camera, screen fogging can be said that one of the problems that plague us often. Fog occurrence is generally associated with the surrounding environment changes, for example, ambient temperature changes frequently, or the surrounding environment has too much soot and dust, will cause fogging. So we choose the network camera installation site, it is best to avoid the air conditioning peripheral, or more water vapor and dust. Due to the structure of the network camera has been rendered more precise trend, so users can do maintenance work has become less and less, of course, this is not a bad thing for the users of the rookie class, because the same means that we in the futuresecurity monitoring work more to enjoy the high-tech convenience brought us, even for a small ip camera to meet the family, social security needs.
|