The garage door installation instructions outlined here are only general and aren't a complete set of instructions. You need to consult your installation manual for total complete instructions. But installing a garage door is not too hard as some may think. The very first order of business are the measurements.
You will need to have some accurate measurements before you can begin. They'll help ascertain what size doorway you need and should be written down so you won't overlook them. First take the height and width of the door opening. This will provide you with your starting point for your figures and more, will reveal what your doorway dimensions will be.
The following step is figuring out the'side-room'. This is the room from the side of your doorway to the garage wall on that same side. You vertical monitor for your typical extension spring and torsion spring, will need that you have at least 3-3/4 from the side. Then for the expansion spring you'll need to get 5-1/2.
Your next measurement will be for figuring out the'head-room'. This is going to be the quantity of space starting near the top of the doorway up to the ceiling. In this example, for an expansion spring you are likely to need 10 and 12 for the torsion spring. If you run into a scenario where you have limited headroom, then there is special hardware created just for that event.
It's time now to find the figures to get the'back-room'. This should add up to all of the height of the doorway is, and another eighteen inches. And just as above, if you plan to devote a garage door opener, then you're going to need more room.
Having your measurements taken and composed, now you can get the doorway opening ready for setup. This wood must match the height of the headroom you quantified just somewhat earlier. They ought to be flat and plumb, and the timber if older ought to be replaced with new. Make sure if you will find any bolts, the heads are down flush and not sticking out in which they could get on your way when installing your brand new door.
We come to the sections. The bottom section becomes prepared . Attach your weatherstripping into the underside section. This can be best done on top of saw horses. This is where you have to follow your guide to a"T" because not all of garage doors are exactly alike. However, this is the place where the lift cable becomes attached in addition to hinges along with your reinforcement strut.
Again, this can be only garage door setup outlined rather than an exact step-by-step instruction for any particular brand. Each one comes with it's personal manual, but this article will provide you some idea about what might be involved if you're considering installing one yourself. It is really not hard when you begin.
From this stage you just attach another sections along with your manage, driving 3 nails into your wooden jambs on each side to hold the sections in place. You may never underestimate your installation manual. Still if you are struggling then Door Installation Queens will be the your ulitmate solution. You will find the highest quality products & service from them.
|