Buying a duct split is a practical device that falls into the following two categories in terms of power consumption. 1- Non-inverter duct split When buying a duct split of this type, the compressors have a constant speed. In this way, after turning on the device, after reaching the desired temperature of the room temperature, it turns off and then turns on, because the amount of power consumption in startup mode is much higher than the power consumption in operating mode. This mode consumes more energy than the inverter model. 2- Duct split inverter In this type, the speed of movement of the inner blade of the compressor is variable. In this way, after turning on the device, after a while, the compressor speed decreases or increases according to the internal temperature. When the room temperature reaches the desired temperature, the compressor speed reaches its lowest point. As a result, the number of on / off compressors is reduced, leading to optimal energy consumption. The energy rating of duct splits without inverter is B and the duct energy rating of inverter splits is A. Their advantage is that they cost less for consumers. The compressor is digital and happens by changing the speed. That is, when the consumption is low, the compressor speed decreases, and when the consumption is high, the compressor speed also increases, because the main energy consumption of the compressors is the starting moment, that is, when the amp consumption increases. So when we reduce the number of beginners, it means we reduce power consumption. In a compressor, the variable speed is generated in such a way that it starts once and its speed reaches the lowest possible speed and increases again, which reduces energy consumption. One of the main disadvantages is that they are short-lived because the compressor is constantly on, another disadvantage is their high initial cost. Lack of experience of repairmen and assistants of these devices is one of the common problems in the country. What is the best duct split? One thing to keep in mind when using Duct Split is not paying enough attention to the quality of its execution. Poor quality of execution makes the worst duct slit unusable and annoying, and on the other hand, poor quality makes the worst devices unusable. In addition to brand selection in Duct Split, the implementation of the infrastructure of this system is also of great importance. How to install and buy duct split The ventilation is done from the air conditioning place or indoor unit in the false ceiling and a valve is installed where necessary and hot or cold air is released according to each season. To produce hot air, a hot water coil is placed in front of the device or behind the device. A hot water coil, which is a coil copper coil of 2 or 3 rows, hot water enters it and this time the same air generating fan passes through that air, takes the heat from the water and turns it into hot air. Submit it to the required spaces. By changing the refrigeration cycle, heat production can be increased. This system has suction and guidance with the channel, which is generally the suction on the back of the device, and this suction causes the air to circulate in total and the heat and cold in the whole environment to circulate and bring the environment to a uniform temperature faster. The best place for the suction valve is 70 cm to one meter above the ground.
Article Source:
https://khabaresf.blog.fc2.com/blog-entry-27.html
|
Author : icoojob |
Views : 34 |
|
|
|
|
This Blog Has Been PowerShared™ Successfully! |
|
|
Check out Infojob's Profile, and Blogs! |
|