Diamond rings have a lot to deal with when worn on a daily basis. So it’s no surprise that the precious stones tend to loosen up in their settings. And losing the centre stone would definitely be your biggest fear.
Even if the setting has been tightened, unforeseen things could still happen. Accidentally dropping the ring, bumping or snagging are some of the factors that can lead the delicate prongs holding the precious stone to slightly bend or loosen. Other factors leading the stone to fall out is a poorly made ring.
Luckily, there are easy solutions to help prevent this disastrous incident from happening and could keep your precious ring as stunning and gorgeous as the day you acquired your bespoke jewellery.
Minimise the Risk
Have your diamond ring checked by a professional jeweller at least twice annually. These jewellers will check the prongs and the stones, just to ensure the metal is in place and there is enough and that all precious stones are securely in their place.
Additionally, practice checking the stones on your ring by yourself at least once a week. In the event that you felt you hit your ring so hard on something, immediately check the stones.
You don’t have to obsessively do this though.
Antique bespoke jewellery such as rings were built to last. However, commonly worn rings, which tend to rub constantly against things, be repetitively in and out of gloves, etc., do have their fair share of wear.
Just keep in mind that you need to be aware of the overall condition of your ring. Get coupon and promo code on deal web.
How to Check the Centre Stone
The method to use when checking the stone would depend on the type of setting on your ring.
Classic 4- to 6-prong setting. Using the edge of your fingernail, run through the stone’s girdle or the outward unpolished edge of the stone. Then, try to move it up or down and back and forth gently.
If you can’t easily do this, then your diamond is most likely secured.
Bezel set or no clear access to the girdle. Using a pin, press gently on the diamond’s most outward point. Then, try moving the stone left to right or up and down checking if the diamond would move along with it.
Note that you have to be careful with the pin. You don’t want to actually accidentally cause the stone to loosen.
Rattling sound test. Now, to check if the diamond is loose, take the ring close to your ear, holding it on the shank snugly. Then, shake the ring back and forth. Listen for any rattling sounds coming from your ring.
In case there’s any rattling sounds or movement coming from the stone, then immediately take your ring to a professional jeweller. Keep in mind that you need to stop wearing the ring until repairs are done.
Don’t Press on the Stones
When putting on your ring, you might have done one of the biggest mistakes many people do with their rings-putting one finger on top of the diamond while the other finger is at the bottom of the shank and then pulling the ring onto your finger.
This often happens when the ring is a bit too snug on your ring finger.
You have to try to resist the urge of doing this. Here’s what you have to be doing-placing your index finger and thumb on the sides of the shank to avoid putting any unnecessary force on the stones.
Summing up
There’s always going to be normal wear and tear for any custom engagement rings, one of the best ways to prevent any precious stones from getting loose in its setting to by removing your ring when engaging in activities such as washing dishes, housework, gardening, etc.
Bio: For more than ten years, Daniel Greenberg has been hand crafting DG Bespoke Jewellery and is known as a trained master diamond mounter and goldsmith. As he was taught by one of the best jewellers in London (his father), Daniel makes certain that all his unique pieces are pure perfection.
|