Toilet Is Not Flushing Correctly |
Posted: December 7, 2017 |
Toilets can encounter many problems, but the most frustrating thing for many homeowners is when a toilet does not rinse well. If this is the case or if the toilet is slowly emptied or after flushing continuously deflates, this can have different causes. However, a wrong rinse does not always mean that you need a new toilet or an expensive call to the plumber. Often homeowners can solve the problem with a few adjustments in the tank. Doesn't Flush at All If the coil lever does not work at all, there may be two problems with your toilet. If the tank is empty, the toilet will not rinse. The tank is filled with water from the supply line that runs in your toilet tank. The flap is usually located on the wall behind the bowl. Make sure the valve is open and then check in the tank if the float is not stuck or obstructed. The second problem may be that the chain that connects the coil lever with the flap is broken or too loose. This prevents the valve from opening and closing and prevents the toilet from flushing. Check the chain or wire that connects the lever to the flap. If it is a chain, remove some links to fix it or replace it when the chain is too tight. If the lever is connected to a wire, loosen the screw on the lever arm and adjust the length of the wire. Bowl does not empty Although sometimes a scale that is not empty, a blockage in the drain indicates, this is not always the problem. If you have dipped or cuddled the toilet and the water in the bowl still won't run away, your water pressure may be too low or the chain that connects the flapper with the flush lever may be too long. Adjust the length of the chain to solve the problem, but if the water pressure is the problem, you may need to contact a plumber to inspect your lines. Slow or Weak Flush Sometimes toilets will flush, but the water slowly runs away or it does not carry anything out of the bowl. This is often caused by dirt and mineral deposits that block the water flow under the edge of the bowl. Scrub under the edge with a rigid wire brush and some white vinegar removes this buildup mostly and resolves the problem. You can also use a straight-made wire pendant to loosen dirt in these holes. A partial blockage in the drain can also cause a slow or weak rinse. The toilet cover is usually sufficient to loosen the material that causes the blockage and to drain the water freely. Continuous Flush If your toilet runs continuously after rinsing, a leak may cause the problem. When the water enters the tank, if the valve is not properly placed over the drain, there will be water in the toilet leaking that it is going to run. Make sure that the float arm is properly lifted and goes down and that there are no obstructions that prevent the valve from falling into place to seal the opening in the bottom of the tank. If the flap is damaged, it must be replaced. Flap press are available from most building markets themselves or as part of a kit with the flap, float arm or float ball. If you want to know more, visit here.
|
||||||||||||||||||||||||||||||||||||
|